Ballon Pop or similar frequency measurement in SignalScope

edited December 1969 in SignalScope Pro
Hi,

I am new to the forum and new to the software.  Does someone have an example of settings you would use to capture the frequency of a balloon pop or single tap type noise with SignalScope?  I tried configuring the waveform options in single mode, but I must not have something else correct.  Thanks.

Comments

  • Does someone have an example of settings you would use to capture the frequency of a balloon pop or single tap type noise with SignalScope?
    You can capture the time waveform of a balloon pop (or similar) with single-shot triggering in the oscilloscope tool. However, the FFT analyzer and oscilloscope are independent tools in SignalScope/Pro, so you can't perform frequency analysis directly on a waveform that you captured in the oscilloscope. Also, the FFT analyzer does not presently support triggering, so performing frequency analysis on a triggered waveform is not currently supported in SignalScope/Pro.

    If that is something you would like to see, please let us know. (When you are offering feedback, the more specific you are about your needs, the better.)

    Ben
Sign In or Register to comment.

We use cookies and similar tracking technologies on our website. This enables us to enhance your experience, provide certain website features and functions, and to improve the services we offer. Learn more in our Privacy Policy.