Welcome, Guest. Please login or register.

Login with username, password and session length
 

News:



Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jeremyajohnson

Pages: [1]
1
SignalScope / Adjust time scale to 1s/div? Voltage measurements?
« on: April 29, 2010, 10:23:59 AM »
I would like to see the measured signal sweep across the screen and have a time scale between 100ms - 1s / div.  Is this possible?  I read in a 2008 forum that seeing the signal sweep across the screen was on the roadmap.  Was it implemented?

Ideally, I'd like to be able to make measurements in Volts, not Pa.  Is that possible?  If not, is there a simple conversion for the mic input?

Thanks!

Pages: [1]