Welcome, Guest. Please login or register.

Login with username, password and session length
 

News:



Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - i_like_macs

Pages: [1]
1
Hello,

I'd like to know whether I could connect either a home-made electret microphone made from Panasonic WM-61A capsules or an Audiomatica MIC-01 via an appropriately wired 1/8-inch TRRS plug. Does the iPhone provide sufficient bias voltage for either mic units? Someone else on this forum mentioned that his iPod Touch (2nd gen.) did not recognise a microphone connection unless it was coerced somehow so that the device auto-detected this.

Many thanks in advance.

2
Hello,

I've just purchased SignalScope for the iPhone after accidentally running into Faber Acoustical's web site, a good fortuitous incident! Wow, now I don't have to use FuzzMeasure for a quick-and-dirty frequency response!

I have read the article regarding the iPhone audio hardware performance (http://www.faberacoustical.com/forum/index.php/topic,54.0.html), but was wondering how accurate the frequency response of its microphone was? Is it flat within its operating range, and what are its low- and high-frequency cutoffs?

I have made my own measurement microphones based on Panasonic WM-61A electret capsules (http://www.panasonic.com/industrial/components/pdf/em06_wm61_a_b_dne.pdf) and compared it against a calibrated Mitey Mike II, so I am aware that these types of devices, similar to what is used in mobile phones, are pretty accurate.

Thank you very much in advance.

P.S. What would be cool is if someone made an adaptor with a threaded mount for tripods, so that the iPhone could be attached like a real SPL meter...  :-)

Pages: [1]