Welcome, Guest. Please login or register.

Login with username, password and session length
 

News:



Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - tinskip

Pages: [1]
1
SignalScope / Re: Triggering
« on: December 08, 2018, 05:12:59 PM »
OK.  I'm going to answer my own question: You have to select a trigger in the Display tab.

2
SignalScope / Triggering
« on: December 07, 2018, 10:59:13 PM »
This is a very basic question, but here it goes.  I am using SignalScope to display an audio waveform.  In this case 440 Hz sine wave.  The display shows an amplitude of about 1 FS, with the waveform bouncing all over the place for lack of re-triggering the scope scan.  Now, I have enabled triggering, created a trigger on the same input, set the threshold to 10 mFS, trigger on positive, auto mode.  Waveform still bouncing all over the place.  I have tried just about every combination of mode, threshold, and slope to not avail.  What am I missing?

3
SignalScope / Frequency Measurement
« on: September 22, 2018, 04:21:55 PM »
I am finding doing frequency measurements with SignalScope to be difficult.  It has to be done visually  and by hand, and there are no physical knobs to tweak the time axis like in a hardware scope.

Ideally the fundamental frequency would be available somewhere.  Am I missing something?

Pages: [1]