Faber Acoustical Forum

Faber Acoustical Products for Mac => SignalScope Pro => Topic started by: paulpiano on February 17, 2012, 02:26:53 PM

Title: oscilloscope triggering
Post by: paulpiano on February 17, 2012, 02:26:53 PM
In SS pro2, is there any way to have both traces trigger from one or the other input, like you can on a real oscilloscope? I'm trying to demonstrate phase cancellation for an acoustics class with two sine waves of almost identical f fed separately to each channel, I want to trigger both from one so that the one stands still while the other migrates left or right depending on its relative f. Years ago I used to do this with a real scope, but it appears as though though SS triggering only works on a per-channel basis. If not in Pro 2, how about in Pro 3?
Title: Re: oscilloscope triggering
Post by: FaberAST on February 21, 2012, 08:50:43 AM
Paul,

Quote
In SS pro2, is there any way to have both traces trigger from one or the other input, like you can on a real oscilloscope?
Sure. In the triggering tab, select the same source for both input channels.

Ben