Welcome, Guest. Please login or register.

Login with username, password and session length
 

News:



Author Topic: Ballon Pop or similar frequency measurement in SignalScope  (Read 8398 times)

0 Members and 1 Guest are viewing this topic.

madtapper

  • Newbie
  • *
  • Posts: 2
    • View Profile
Ballon Pop or similar frequency measurement in SignalScope
« on: December 07, 2009, 03:26:53 PM »
Hi,

I am new to the forum and new to the software.  Does someone have an example of settings you would use to capture the frequency of a balloon pop or single tap type noise with SignalScope?  I tried configuring the waveform options in single mode, but I must not have something else correct.  Thanks.

FaberAST

  • Administrator
  • Sr. Member
  • *****
  • Posts: 318
    • View Profile
    • www.FaberAcoustical.com
Re: Ballon Pop or similar frequency measurement in SignalScope
« Reply #1 on: December 08, 2009, 08:57:44 AM »
Quote
Does someone have an example of settings you would use to capture the frequency of a balloon pop or single tap type noise with SignalScope?
You can capture the time waveform of a balloon pop (or similar) with single-shot triggering in the oscilloscope tool. However, the FFT analyzer and oscilloscope are independent tools in SignalScope/Pro, so you can't perform frequency analysis directly on a waveform that you captured in the oscilloscope. Also, the FFT analyzer does not presently support triggering, so performing frequency analysis on a triggered waveform is not currently supported in SignalScope/Pro.

If that is something you would like to see, please let us know. (When you are offering feedback, the more specific you are about your needs, the better.)

Ben